HomeDocumentationChangelog
HomeDemoContact
HomeDemoContact

Configuration

Configure an external data source as a Destination, to enable writing out anomalous records.

1. Select type

Click + New destination and select the data source integration used for your Destination connector.

Destination configuration wizard - Select Destination type.

Destination configuration wizard - Select Destination type.

2. Credentials

You can either select configured Credentials with access to the particular Destination, or create a new one.

📘

Credential parameters look different depending on the Destination

For more information, refer to the respective Destination type page.

Destination configuration wizard - Select Credentials or create new Credentials.

Destination configuration wizard - Select Credentials or create new Credentials.

3. Config

Configure the parameters for your Destination connector to complete the integration.

📘

Configuration parameters look different depending on the source

For more information, refer to the respective Destination type page.

Destination configuration wizard - Destination specific config parameters.

Destination configuration wizard - Destination specific config parameters.

4. Activate the Destination

After completing the steps in the wizard, you can select the Destination in the config step when configuring a Validator. Anomalies identified by the Validator will then be written out to the Destination.

📘

Supported Validators

Currently, Destination connectors are only supported for the Numeric anomaly and Volume Validator types.